|
Farmall & IHC Tractors Discussion Board |
Re: 6
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Topic on March 11, 2007 at 12:38:26 from (208.252.179.27):
In Reply to: 6 posted by Kevin Sonnentag on March 10, 2007 at 18:40:24:
You might want to put what your subject something different than 6, i dont thing people would look at it if it just says 6. Brain Dead, you have to get it for little or nothing for something like that, if i was you i would stay away. There is alot of hidden problems in those junks the PTO will work but when under pressure they will slip, the hyds seem good until hooked up, if you have a hyd guage test them, a new one will cost you $600, The tractor might be worth $300 for scrap, about your T/A, you would have to get that tractor for $2000 good luck.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|