|
Farmall & IHC Tractors Discussion Board |
Re: 404 or 444 Crank ??
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by VinnyJimbo on March 01, 2007 at 12:55:46 from (129.33.1.37):
In Reply to: Re: 404 or 444 Crank ?? posted by ejr-IA. on March 01, 2007 at 09:36:29:
What I was trying to say was crank journal dia for 404 in my book says 2.1245. Crank measures 2.620 which is about what the dia is for a 424 or 2424 or 444 or 2444. I"ve nosed around in this forum and I"ve seen some words thta say the later ser num 404 (100501 and above) has a larger dia crank than earlier numbers. I"m beginin to suspect that my manual list specs for older ser num 404. Just looking for confirmation.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
