|
Farmall & IHC Tractors Discussion Board |
Gen to Alternator conversion wiring question (3 wi
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nawlens Gator on February 26, 2007 at 08:14:17 from (52.128.30.23):
Where does the 18ga wire with diode from the alternator go? I understand the load side of the inition switch, but I have 2 different key switches (2 tractors, both IH 140's, 12V neg Grnd). One has a 2 position key switch that sends votage to the coil when on, and a push button switch that turns the starter over with or without the key switch. The other has a 3 position key switch that sends voltage to the coil when in position 2, and voltage to the magnetic relay (which engages the starter)when in position 3 (spring loaded, temporary on). I'm guessing the 18 ga wire with diode goes to the coil side of the key switch in each case. Am I right? Any help appreciated.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
