|
Farmall & IHC Tractors Discussion Board |
Re: Farmall 300 questions ???
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Sam F. on February 26, 2007 at 07:04:01 from (66.53.120.191):
In Reply to: Re: Farmall 300 questions ??? posted by jpl on February 25, 2007 at 22:10:38:
When I got it home, I put a 12 volt and since the cable ends fit with negative ground I wired it that way and when the tractor started, amp guage showed charging this way. Tractor had not run in 3-4 years, so I ended up dropping bottom of carb to free the float up. Tractor runs fairly good on a nurse bottle for a tank. Gas line kinked and small split. Does it use the longer glass sediment bowl ?? Has the short one on it now, of course which leaks (gasket). Has perfect condition lights, including the red stop light inside the work light on rear. How much hydraulic oil does it use ?? And weight or type ??? Thanks guys !!!
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|