|
Farmall & IHC Tractors Discussion Board |
Re: Will M - crankshaft fit in a 400
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ejr-IA. on February 21, 2007 at 16:24:07 from (204.11.182.50):
In Reply to: Will M - crankshaft fit in a 400 posted by SDE on February 21, 2007 at 15:19:31:
Need to know the serial no. of the M.Early Ms had smaller mains and rod bearings.The break was at syn.278049 acording to the book I have.Also do a measurment on the shaft to make sure.These are the measurement for the 400 rods 2.547-2.5485 Mains 2.8075-2.8085
Replies:
Home
| Forums
Today's Featured Article -
Product Review: Electronic Ignition - by Staff. Oil, for example has come a long way in the last 50 years and I don't use anything but the latest API grade available. I've heard the arguments for non-detergent oils but would never trade it for today's formulations. Paint is another, the modern acrylic enamels are great for resistance to grease and fuel stains, retaining their shine and they last forever; unlike enamels and lacquers . Still another is the alternator. No doubt using the original generator keeps the tractor pure, but for thos
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
