Farmall & IHC Tractors Discussion Board |
Re: Sticky Valve(s) on 1944 A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bama Binder on January 18, 2002 at 13:52:26 from (206.5.110.200):
In Reply to: Sticky Valve(s) on 1944 A posted by EZHangin on January 17, 2002 at 20:09:30:
The Cub is a little different than an A in that you can work on loosening the valves through the spark plug hole...I know because I was able to get a Cub going after loosening 3 very stuck valves. They are still free....they just needed some run time. My Super H is a different story...it had some rust on #1 spark plug. Every now and then you will hear a "pop" through the exhaust. That is a sign of a sticking valve. If you hear that "pop", try taking a putty knife or something similar and holding it over the exhaust when it is running..when you hear that pop, the knife will be sucked back down. You can see the rain cap doing that too.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|