Farmall & IHC Tractors Discussion Board |
Re: Re: H steel rear wheels
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on January 16, 2002 at 21:01:20 from (128.242.4.59):
In Reply to: Re: H steel rear wheels posted by justin on January 14, 2002 at 06:41:03:
You should be able to measure the axel of an H and then measure the axel hole in the wheel (remember that the hole in the wheel has to be drawn down). The H wheel's won't fit on an M and I don't believe they will fit on the F series either. M axels are bigger and I believe the F-series axels are smaller. I bought a 1940 H parts tractor on complete front and back steel for $700. I thought afterwords that that was a little high but I really wanted the wheel's. It was probably worth it in the long run becuase I pretty much got that old tractor stripped down to nothing.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|