Farmall & IHC Tractors Discussion Board |
M Camshafts / MW Governor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Deere on January 14, 2002 at 19:27:33 from (66.153.8.35):
I need more 'technical' advice! I am still bringing my parts together for the "M" overhaul & thanks to you guys have located several heads (Even some close-by!!) and a sleeve puller. My next question is regarding camshafts - Is there a better IH-built alternative to the stock "M" camshaft (i.e. 400-450?) - If I have one re-ground, should I use my "M" shaft, or opt for something else as a 'base'. (Firecraters & gasoline / 450 head) Also - a friend said that the M&W governor is a better alternative to be certain that the throttle butterfly is w/o when needed - Where can a guy find one in good shape? If you know, feel free to e-mail - it worked great for the heads! (I know Denny's sells their 'mod' units, but I've had several of my pulling friends say that they're dissapointed in the mods/lack of adjustability) Thanks again - you guys are as great as the Deere boys!
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|