Farmall & IHC Tractors Discussion Board |
Re: rebuilding super a steering box
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on January 07, 2002 at 07:53:01 from (129.37.117.9):
In Reply to: rebuilding super a steering box posted by joe on January 06, 2002 at 18:18:40:
The steering box is not complicated. Hardest part will be you have to remove the front axle to do a rebuild. Be sure to replace all the seals while you are in there and double check all the bearings and bushings to be sure they have no play and replace them too if in doubt. Before you take the axle off, you may want to check the thrust bearing on the worm gear to see if it is worn. You can do that by taking the big plug out of the front of the gear housing and then screwing the worm out far enough to check the bearing for play. Drain the oil out of the gear first.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|