Farmall & IHC Tractors Discussion Board |
Farmall M Rebuild
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Phil - New to Farmall on January 02, 2002 at 08:04:36 from (156.77.66.117):
I'm a long-time Deere man who has decided to add some new color to the machine shed, to balance out the green and prairie gold. I have purchased a '44 "M" and plan to rebuild the motor (I believe that it has a broken ring on the #2 cyl - Bottom end is relatively tight & carries good oil pres). I have some questions 1) Can the sleeves be pulled without fully removing motor from frame? 2) How stubborn are the sleeves when being pulled? 3) Is there an OTC tool number for the puller? Also, without stroking the motor, what are the best ways to get power from the red beast? I've pulled against some fairly stout "M's" with my "G" & know it's cheaper to build the "M" than a Deere......Thanks in advance!!
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|