|
Farmall & IHC Tractors Discussion Board |
Re: M's rpm
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red on December 26, 2001 at 10:54:34 from (206.246.187.2):
In Reply to: M's rpm posted by church on December 26, 2001 at 09:02:19:
You might or might not get more RPM. M RPM only runs around 1,600. With the engine off, remove the side plate on the governor housing. You will see a yoke on the left with two adjusting bolts. The lower bolt is the high speed adjustment. If very much of that bolt is showing left of that yoke, loosen the locking nut and turn the bolt counter clockwise so less bolt is showing left of the yoke. Tighten down the locking nut, install the cover and fire her up and see if you pick up RPM. Let us know if this helps.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Harry Ferguson - The Man & The Machine Harry Ferguson was christened Henry George but every one called him Harry. Harry was born in a small Irish town called Growell in County Down about 16 miles from Belfast. Harry Ferguson led a varied and colorful childhood causing mischief where ever he could. He showed mechanical aptitude at a very early stage in life and showed no inclination towards
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|