Farmall & IHC Tractors Discussion Board |
Re: Overhaul kits - In-frame kit??
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark on December 24, 2001 at 14:12:00 from (152.163.205.61):
In Reply to: Overhaul kits - In-frame kit?? posted by Dave G on December 24, 2001 at 06:14:38:
An overhaul kit contains all the gaskets needed to rebuild the engine out of the frame, this would be what you will need if you are removing the crankshaft, an inframe kit is a head set and oilpan gasket, used for piston,liner replacement etc. under size bearings are available and could be supplied by the shop that turns the crank, or any engine part supplier such as clevite.
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|