|
Farmall & IHC Tractors Discussion Board |
Re: H Pinion shaft whine
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on December 19, 2001 at 09:05:51 from (165.170.128.65):
In Reply to: H Pinion shaft whine posted by Bleedinred on December 18, 2001 at 20:10:36:
My opinion: You're gettin old and crochety.... Seriously, if the tranny whines in 1 thru 4 and reverse but not in 5th, problem's likely with the input shaft/countershaft constant mesh gears. Proof is to put a load on the PTO with the transmission in neutral. If you again hear the whine it's gotta be the constant mesh gearset - since that's the only pair in contact and carrying a load. Whine could be because the gears are badly worn, or improper shaft spacing is causing incorrect tooth clearance (either too tight or too loose) at the gear mesh.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
