Farmall & IHC Tractors Discussion Board |
Re: LEAKING VENT
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Doc on December 14, 2001 at 19:30:00 from (209.173.231.50):
In Reply to: LEAKING VENT posted by budaa on December 14, 2001 at 18:41:40:
The manual for the remote control hydraulics for an M says to close the vent on the breather when using remote control hydraulics, does not say why, but I guess we now know why. This is for the factory remote control valve that is attached to the breather/fill pipe with a tee, sounds like same as you have. Try it. I don't have a dipstick on my M. I changed the oil, and measured from the top of the tee, and have 12.5 inches to the top of the oil. your measurement may be different. If nothing else, dump the oil, fill with fresh, and measure. I think I have seen the measurement here on the forum, maybe do a search, or someone will know it. Doc.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|