Farmall & IHC Tractors Discussion Board |
Re: putting JD loader on M-will it fit?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by #45 Loader on November 22, 2001 at 05:13:38 from (209.240.222.132):
In Reply to: putting JD loader on M-will it fit? posted by Kenny Christopherson on November 21, 2001 at 21:52:31:
When dad sold the farm ,I bought the 44 "M" and with a 45 JD loader on it. no problem installing on "M" only couple things we did to strenghten loader ---1) we welded large pads to axle loader mtg bkts. 2) same with brace bar frame mtg. 3) welded 3/8 x 3 flat from xmember(like wings horizontal)(by bucket) to end of loader horn(where bucket is pinned to loader. horns on this loader is weaker then rest of loader. 4) left snow wings on bucket and went to larger lift rams and converted to hyd. bucket. Go for it the 45 loader is one of the better of the antique loaders. I like mine very much when I restored the "M" the loader was painted IH red to match. Good Luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|