|
Farmall & IHC Tractors Discussion Board |
Re: 3pt on an SC?Your Kiddin, right?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Clyde on November 15, 2001 at 04:28:06 from (63.146.82.171):
In Reply to: 3pt on an SC?Your Kiddin, right? posted by IaGuy on November 14, 2001 at 17:41:46:
I'll get some pictures taken and posted. The little block they fabricate to get into the original hydraulics is kind of interesting. It mounts between the manifold and the touch control box. So when the new control is in the center open position the original touch control work just like normal. Even if your TC box is bad as long as it holds oil as a reservoir it would still work with this system. Other than hoses nothing else hooks up to your original touch control. Their setup for a C or SC looks just like the one they sell for H's and M's except this one only has 1 cylinder.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
