Farmall & IHC Tractors Discussion Board |
Re: Old Rusty H Heading To The Farm
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chums5 on November 11, 2001 at 06:03:11 from (209.240.222.132):
In Reply to: Old Rusty H Heading To The Farm posted by The Red on November 10, 2001 at 10:48:28:
The Red....nice pics of Old Rusty and the start of you restorations....BUT...don't ever send that "wreaker or operator" to Wis. cause far as I'm concerned he moved Old Rusty very unsafely and luckly he didn't LOSE him on the trip to the farm..!!.....sorry but I've moved lots of equip. & vehicles over the yrs. and use alittle more care in moving them.....and I'm sorry I have "never" pulled a tractor down the road...they are driven or trailered only.....and I just want you to know I learned from my dad(had a wrecker service for 25 yrs)and I have It know and we will move almost anything and or retreve anything......Sorry but Good Luck on your restoration.......that's my two cents...
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|