Farmall & IHC Tractors Discussion Board |
Re: Super C Implement pictures
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by J. D. Humm on November 03, 2001 at 16:01:42 from (12.65.204.125):
In Reply to: Super C Implement pictures posted by wayne on November 03, 2001 at 15:37:46:
I would like to know that also. The owner's manual has a few pictured but not all. I have 3 of the two point, two bottom plows, a two point 6 ft perfect and rare disc, a pitman type sickle mower and a balanced head two point mower, a front mounted cultivator with the two point rear attachment, a two point 6 ft IH blade and a rare implement that resembles a field cultivator, it is factory built and has 7 coiled shanks with shovels. I had never seen one until I bought this one. We also have a homemade 2 point carryall, 3 sets of front wheel weights and 6 sets of rear wheel weights.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|