|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: IH 1206 Rear Seal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on October 18, 2001 at 17:22:09 from (216.196.13.1):
In Reply to: Re: Re: IH 1206 Rear Seal posted by ihdoug on October 18, 2001 at 09:02:55:
The only thing that you could have done wrong is maybe that you got the seal in backwards or that you got the wrong seal somehow? they are not hard to change and they are almost fool proof. The only thing elese is that your mains are woren so bad that the crank is bounceing up and down . Did you replace the PTO bearing? some time if the bearing has to much ware it will cause the seal to leak? It has been about two years since i have worked on a 1206 and that was a total rebuild. If you still have problems give me a call on the land line at 330 337 8113 after 9 pm Ohio time i will try my best to help you out.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractors and the City Boy - by Ken. A few years back I came to the conclusion that city life wasn�t for me. The houses so close together you could hear the neighbors fight, traffic so heavy speed limit signs meant nothing. So I started looking for the ultimate country setting. After many months I found the perfect place, off the beaten path, up a private � mile drive, old stone house which has stood the test of time, out buildings which haven�t stood the test of time, trees, birds, rabbits, and snakes. This is the place! Bought
... [Read Article]
Latest Ad:
65 Massey FERGUSON DIESEL
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
