|
Farmall & IHC Tractors Discussion Board |
Re: Super C starter Bendix Repalcement-How To??
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy Martin on October 16, 2001 at 21:23:52 from (63.26.133.3):
In Reply to: Super C starter Bendix Repalcement-How To?? posted by Mark on October 16, 2001 at 17:25:22:
There is only one safe way to crank a tractor. Stand with your right side at the front of the tractor, lift the crank from bottom with four fingers of the right hand around the handle. Lift only 1/4 turn. Back the crank down and lift again. Never crank over the top. Never crank all the way around. You really can break your arm. You break your arm by cranking wrong. The tractor does not break your arm because it does not know you exist. Most Farmalls in good shape will crank in two or three lifts. When the tractor kicks back it will open your fingers and not break anything. If it kicks regularly, retard the timing a couple of degrees. Timed right they rarely kick. A starter shop will replace your Bendix if you have trouble. Your ring gear is probably OK.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Horsepower Defined - by Staff. Indicated Horsepower This represents the power developed in the enine cylinder as obtained from the pressure in the cylinders. This is pressure obtained from an indicator which shows cylinder pressures. Indicated horsepower does not represent the actual useful power delivered by the engine. Brake Horsepower This is the actual horse power delivered by the engine to the shaft. It is equal to the "indicated horsepower" less the friction of the engine. It is useful hor
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|