Farmall & IHC Tractors Discussion Board |
Re: 450D - normal starting?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Roger on October 11, 2001 at 19:18:33 from (209.224.32.232):
In Reply to: 450D - normal starting? posted by bsinn on October 11, 2001 at 17:32:05:
I recently restored a Farmall MD which has the same engine as the 450D. The 450D should start on gasoline like a gasoline 450 except for there is no throttle so it runs at a fixed speed. Parts are hard to come by for that engine including the carburator and injector pump. If you need to have the injector pump rebuilt it can cost $1000. There is a lot of complexity to the engine because it can run on gas and diesel. I spent a lot of time adjusting linkages, setting the timing on the injector pump (trial and error), etc. When I was done it is a great machine to drive, especially when you switch to the diesel mode. This engine was quite a design by the old International Harvester engineers of the late 1930's/early 1940's. Roger
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|