Re: Farmall 450 noises

Posted by Denny Frisk on October 11, 2001 at 10:30:51 from (12.4.181.2):

In Reply to: Farmall 450 noises posted by BEL on October 11, 2001 at 04:33:37:

Dad's 450 did that too when He had it back in the late '60's. First check to make sure the wheel clamp bolts are tight, the 4 that clamp the cast wheel to the axle. While Your doing that check to make sure the rim clamp bolts are tight. If they all check out O-K, Your problem is probably the same as Dad's was. The bull pinion shaft bearings are getting bad and the pinion shaft is walking back & forth against the bull gear. Pull the brake housing off and try wiggling the shaft real hard. Get a manual before You try to remove the bearing housing. There's also a slim chance it may be the rear axle carrier bearings but a real slim chance.

Follow Ups:

• Re: Re: Farmall 450 noises BEL 06:07:20 10/13/01 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Farmall 450 noises Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]