|
Farmall & IHC Tractors Discussion Board |
Re: Trailer Brake Wiring Help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George Willer on October 08, 2001 at 07:21:59 from (64.254.131.46):
In Reply to: Trailer Brake Wiring Help posted by cheg on October 08, 2001 at 07:08:03:
Cheg, I did that same job on a newly acquired trailer just last week. I'm sure it doesn't matter which side of the coil is grounded...or there would be a way to identify which is which. Be sure to use a round trailer connector so you have enough conductors for a properly wired ground. I believe in keeping the plugs standardized, so you can interchange several trailers between several vehicles. Are you using an electronic controller? George Willer
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Removin Broken Bolts - by Staff. Another great discussion from the Tool Talk Discussion Forum. The discussion started out with the following post: " How would I remove a bolt thats broken off in a piece of metal and I want to save the treads in the metal and then put in a new bolt. "
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|