|
Farmall & IHC Tractors Discussion Board |
Coolant in Oil
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jeff on October 05, 2001 at 10:13:32 from (63.150.94.35):
Problem: I have coolant in my oil pan (Super M-TA). This is a recent development, maybe the change in weather opened a hole (I haven't used it much in the last few weeks). The valve head (refurbished from a reputable place) and gasket are new, there's no white smoke in the exhaust (exhaust is clear), and there's no oil in the radiator. I'm assuming the crack is in the coolant/lower engine wall somewhere or maybe the head gasket or head have some sort of leak. My fixes are to tighten the head bolts down after the engine warms up (I initially tightened them cold at 110 ft-lbs and never went back and checked them) and to add Ceramic Engine Seal (this worked on my H). The engine sat outside for about 10 years with about half the coolant in it until I restored it. Any other suggestions?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|