|
Farmall & IHC Tractors Discussion Board |
farmall h needs help again??
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by derek on October 04, 2001 at 18:31:37 from (12.30.224.17):
my h had a vaccum leak.turns out the manifold was shot.replaced and put new gaskets on.purred like a kitten that night. the next mornin i went to start it and it would start . just pissed gas out of the carb. pulle a plug and it gets about 3 weak sparks then stops no matter how long you crank it.the kill switch is real hard to pull out and i think it may be that.however i had a man go through my magneto. he set the rotar just a touch off and it ran rough . he said it needed a valve job but i settled that with him lkater on. could he have screwed up my point i dont think he new what he was doing.i realy got to figure this out its my main work tractor . my father has a john deere a but i would be caught dead driving it . HELP!!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|