|
Farmall & IHC Tractors Discussion Board |
Re: Super A burns oil
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy Martin on October 04, 2001 at 12:16:07 from (63.27.17.36):
In Reply to: Super A burns oil posted by Dan M on October 04, 2001 at 11:14:58:
I agree, slight oil burning is nothing to worry about. As long as you can afford to replace the fouled plugs, keep using it. Tell the neighbors you are fogging for mosquitoes. At the next oil change, pull the pan and remove the oil pump cover. It can be lapped on a piece of glass using valve grinding compound. If it is grooved or worn, a little clean up will help oil pressure. You don't have to clean it all the way up to get results. I have a C in poor shape that I brush hog with. Same engine as the A. It smokes like a fish when first started. Requires new plugs every 20 hours or so. I run it 200 hours or more per year. Oil pressure drops to near 0 on the gauge when it warms up. It has been this way for several years and has not developed additional problems from the low oil pressure. I did change to 20w50 a few years ago. I'm sure it needs the oil pump treatment as well. While you have the pan off, you'll notice the crancase is not all that dirty. I'd change to 20w50 detergent oil even without removing the pan. I farm with Farmalls (mainly M's and H's)and have used detergent oil exclusively for over 20 years. Never pre-treated one and never had a problem. I own 28 and help neighbors with 10 or more additional ones. I say this to say I am not guessing with my advice, it comes from experience. I just don't buy in on the fear of detergent oil. It is also a superior oil to non-detergent oil you buy, so you get extra protection.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|