Farmall & IHC Tractors Discussion Board |
Re: Rebuilding Super C Hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave T on October 04, 2001 at 11:11:24 from (63.20.49.126):
In Reply to: Rebuilding Super C Hydraulics posted by Indiana Jones on October 04, 2001 at 05:24:21:
Case IH has a gasket and seal kit for your cylinder unit for around $90. It just has a few gaskets and gobs of o rings. There is a real good blowup of the unit in the I&T service manual. It's not too hard to tear into. Just take your time. Place it on your bench upside down and place things on your bench as you take them out. It took me a couple of hours to take apart, not that it should take that long, but trying to memorize everything as I removed it was important to me....Not much to the pump...
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|