Re: putting new wiring in my C light bar

Posted by Haas on September 28, 2001 at 16:45:17 from (129.37.117.165):

In Reply to: putting new wiring in my C light bar posted by Dennis on September 28, 2001 at 14:47:29:

Well, it was a lot of "fun", but I got new wire in on my 1950 C. The old wire was so rotten, it could not be used to pull in new wire. First, as the others said, get everything all cleaned out. Mine was full of dirt, too. Then take out the battery and box if you have one (likely you've already done that). Then push the wire up through from the panel. By shining a light through the bar, you can see when it gets to the bar. Then use a rod, or another wire with a loop in the end to snag the wire and either push it out or pull it on out of the light bar. It's not easy to get the wire around that right angle turn, but it can be done.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: putting new wiring in my C light bar Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]