Farmall & IHC Tractors Discussion Board |
Re: Hydraulic Question on M Belly
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on September 24, 2001 at 14:30:36 from (129.37.117.68):
In Reply to: Hydraulic Question on M Belly posted by Alabama on September 24, 2001 at 11:02:09:
You can put as many lines and spool valves on the belly pump as you want. Just remember it has limited flow and pressure capability. Only generates about 800 psi. Not sure of the flow. To use spool valves, run a line from the lift all output to your spool valve inlet and run the return from the spool valve into the fill port of the lift all. The fill port is on top in front of the belt pulley. Then when you wnat to use your spool valves, lock the lift all in the lift position so that fluid flows through the spool valve all the time.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|