|
Farmall & IHC Tractors Discussion Board |
Re: 140 Whats a good price?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Glenn(WV) on September 21, 2001 at 19:53:20 from (63.14.187.228):
In Reply to: 140 Whats a good price? posted by Farmall ED on September 21, 2001 at 18:19:41:
Without knowing how well it runs(or if it does), it's a little hard to say. Something is worn out inside the steering box - the steering has way too much play in it. Needs new wiring harness, needs a complete paint job, needs new tires, who knows what the engine may need - If it runs OK, I'd start at $1000-$1300 and see where it goes. If it doesn't run but the engine turns freely, I'd start at $750 or so; if the engine is stuck, I'd start at $250 and not go past $500. Fixing a stuck engine can cost big bucks! My numbers may be low, but I tend to be a little cheap starting out. ;-) I don't try to rip people off, but why pay more than is necessary?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|