Re: flywheel torque and input shaft coupling

Posted by Theman on September 19, 2001 at 07:35:06 from (12.19.86.5):

In Reply to: flywheel torque and input shaft coupling posted by chris on September 16, 2001 at 20:17:57:

I don't remember an actual figure but I tightened mine as tight as I could with a 12" ratchet. Those bolts shouldn't strip in the crankshaft at around 100 ft-lbs. Make sure to bend over the locking tabs to prevent loosening.

The tapered bolts in the coupling should take out all the slack. If I'm reading your post correctly, it sounds like you have worn holes in the wavy part of the coupling. The rubber grommets should only allow a very small amount of flexing. If you can twist the clutch shaft at all without moving the transmission input shaft you have too much wear.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: flywheel torque and input shaft coupling Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]