|
Farmall & IHC Tractors Discussion Board |
Re: Tin work on Super M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on August 29, 2001 at 09:09:43 from (165.170.128.65):
In Reply to: Tin work on Super M posted by Bill Sires, Jr. on August 29, 2001 at 06:26:08:
Bill - Check also that the top surfaces of the grille and gas tank are level with each other. Sometimes the padding (soft washers) between the tank mounting brackets and the bottom of the tank are deteriorated, or are missing altogether. The tank then rides low relative to the grille. The hood sloping down to meet the gas tank results in a noticable mismatch and gap where top front edge of the hood meets the grille. My Super H had this problem - can see it in this photo. Installing new padding and raising the tank about 1/2" cured the problem.
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
