|
Farmall & IHC Tractors Discussion Board |
Farmall H rim clamps - more questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by glenshoe on August 27, 2001 at 11:25:32 from (198.246.67.52):
Sorry to beat this to death, but still not clear on this and my tractor is 100 miles from home so can't run out and look. My owner's manual has no details on this. I was able to get some rim clamps to replace the ones I'm going to have to cut off, but no bolts, washers, nuts, etc. I'm pretty sure the originals have square heads. Do I need square head bolts or will hex head do? What size and grade do I need? Do I need lock washers, etc. I think I saw something in the archives about rim clamps being "double nutted". I don't recall seeing anything like that on mine. If this is the case, how and where should they be double nutted? Also, what is the proper orientation of these clamps--looks like the inside goes one way and the outside the opposite way, but I don't want to take anything for granted on whether this old tractor is set up correctly. Any and all help appreciated.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
