|
Farmall & IHC Tractors Discussion Board |
Re: Re: Brakeson Model504
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by J.D. Humm on August 26, 2001 at 08:17:36 from (205.188.200.191):
In Reply to: Re: Brakeson Model504 posted by J.D. Humm on August 26, 2001 at 07:47:11:
Looked in my 504 manual. Free travel on the I504 is 1 7/8 inches. This is achieved by adjusting the threaded rod I talked about in last reply. More hints- There are 2 line up pins that may come out with brake housing or may stay on bull pinion bearing housing. Remove them from housing and place in matching holes on bull pinion housing. This will aid in reassembly. Remove plug in brake housing before reassembly. (looks like the cap on your front wheel hubs) This lets you look at splined shaft to make sure all components are on shaft before you try to bolt housing back on. KEEP EVERYTHING CLEAN.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Mud Daubers and the Old John Deere - by Jon Zehnder. I have a 1941, John Deere Model A tractor I have owned for about a year and a half. This is my first (in case my wife reads this, "FIRST") tractor and it has been a learning experience. After considerable advise and assistance from local tractor nuts and the forums of Yesterday�s Tractors, I had finally got it running pretty well. I have tuned it up, overhauled the carburetor, installed a borrowed, rebuilt magneto, installed a new Power-Trol, patched the radiator, installed new front wheels a
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
