|
Farmall & IHC Tractors Discussion Board |
Bought an M!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Red on August 13, 2001 at 13:33:32 from (12.84.247.69):
A big thank you to LazyHorse over on Tales. He thoroughly checked it out for me. It is located about 10 miles southeast of my farm. Tin is straight and rusty. Engine and transmission ran good. Tires are about 30%. PTO works. It is 12 volt and it is charging fine. It was out in the field pulling hay wagons today. Paid $850 and should be delivered later this week. This one will go on the tax rolls and be used to pull hoppers in the Fall harvest. I will more than likely part Old Rusty H and let some of you have needed parts. At least that is the current game plan.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
