|
Farmall & IHC Tractors Discussion Board |
Farmall 400, 450 Cylinder head ( I m getting a complex here!)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by On2Wheels on July 31, 2001 at 11:52:55 from (208.3.193.5):
It's me again. As I mentioned before I have replaced my standard M block with a Super M block which I think is a 450 (C281). There have been some differences, but I have overcome them pretty much with your help and others...Thank you for that. Now the question. On the standard M head there is a fitting that goes to the air cleaner that enters the rear side of the head. There is another fitting that is inside the valve cover, one toward the back and another one in the front. Running between those two fittings is a pipe that screws into both fitting. On the front side of the head there is another fitting that the govenor pipe is screwed into. After all said and done the air cleaner draws air causing a positive crankcase venlitation from the govenor. I really hope I am making myself clear here. But on the 400, 450 head the only place where fittings could be screwed into are in the front side and inside the valve cover on the front side of the head. There is nothing in the back for the air cleaner can attach to. Is the valve cover different between the standard M and the 450? If so can I modify my current valve cover and what does the inside fitting have attached to it? Boy I really wish that there where rendering online like the IH dealers have. Thanks, Dave
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|