|
Farmall & IHC Tractors Discussion Board |
Re: Re: little off topic, but I have alfalfa question?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on July 30, 2001 at 22:40:56 from (128.242.4.59):
In Reply to: Re: little off topic, but I have alfalfa question? posted by David Saville on July 30, 2001 at 21:41:55:
I seeded it on the 10th of May and it sat for over 2 weeks without rain and then we got a pretty good one. Warshed a little on the steap ground and back sides of terraces. Silted in a little in the level areas and terrace channels. Where it washed and silted is the major area's where there isn't hardly any alfalfa at all. I used Kansas Common alfalfa seed which was relatively cheap. I bought the seed at a local coop and the bags were unlabeled. Not sure what the germination was becuase of this. I put on 8lbs to the acre. My neighbor puts on this amount and says that that amount works pretty good for him. I am wondering if the weed problem might be thinning down whats there due to the canopy and smoothering it when it is mowed off. I took this into consideration when I mowed it the first time. That is why I mowed it off as high as the sickle mower would go. The stubbel seemed to stick up through the mowed off weeds where there was alfalfa. The thinner the alfalfa the thicker the weeds though. I think the time has expired for any more sprouting since we have had adequate rain since 2 weeks after the seeding. Where the alfalfa stand is poor, is it becuase of weeds or are the weeds volunteering there becuase of no alfalfa? How much damage can weeds do to a field like this? I just really wish I knew what to do. I hate to sit here and do nothing when there is a time limit on reseeding. I may be able to save field now but maybe not later.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
