Re: M Sleeve Will Not Budge

Posted by justin on July 13, 2001 at 18:34:27 from (209.23.129.28):

In Reply to: M Sleeve Will Not Budge posted by John on July 13, 2001 at 16:15:38:

Sounds like you are probably binding the puller plate against something. Make sure that your puller is squared to the block. It may not hurt to pork on the outer diameter of the puller plate, as it might be just a touch larger than you would like. Sometimes the sleeves are tough to get moving, so you may not have enough pressure on the sleeve, but then again be careful not to tighten the plate too much if there is a possibility that the plate is binding on the sleeve retaining wall.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: M Sleeve Will Not Budge Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]