Farmall & IHC Tractors Discussion Board |
Rear wheel weights,cornpickers and farmalls
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Michael Soldan on July 01, 2001 at 14:26:16 from (216.46.140.186):
I was cleaning up two sets of rear wheel weights today readying them for painting and I noticed one weight had a wear mark about an inch and a half wide all the way around the outter edge. I kept looking at this mark and although I have four sets of rear wheel weights I have never come across this grooving or wearing. Could the rear weight have been on a tractor with a mounted corn picker that was rubbing on some component of the picker? I've never had a corn picker so I was wondering. Wheel weights come in various condition Some are good clean castings and others I have are poorly poured probably war years weights. I just fill the imperfections with liquid metal and sand them off. Some have a parts number that is about 1\2 Inch high and the international logo others have a huge parts number about an inch and a half high with logo. One has a square mark stamped beside the logo. I am curious about the differences, the part numbers are all the same so it must be different eras they were made in. I am putting two sets on my H and a set of front weights as well This H is going to pull a 3 furrow I-H drag plow on Kerosene. This was my goal for restoring the H. My other H is loaded and I'm getting it pumped out and will install a set of weights in place of the calcium. I am looking forward to switching the H over to kerosene for an afternoon of fun with my tractor fiends. If any on can guess how the wheel weight got worn give me a shout. Mike in Exeter Ontario.
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|