Farmall & IHC Tractors Discussion Board |
Model M gov.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom/Idaho on June 21, 2001 at 14:40:31 from (63.28.208.27):
I have a 1940 Farmall 'M' that just recently started 'govenor hunting'. In fourth gear at about half throttle the engine will surge. When hooked up to a dyno or in a pull it does what it was designed to do without a miss. In the service manuals and dealer parts book it shows a 'thrust washer' in front of the govenor sleeve. All H,M,300, 400 and supers have the same govenor and show the washer. Mine does not have the washer. Mine ran great till I rebuilt the card and then it started hunting. On the front of the throttle shaft housing where it bolts to the top of the govenor housing there are two screws that hold it in place. They are slotted! Someone told me you could make it stop 'hunting' by moving this up or down. I KNOW THE LINKAGE is adjusted as per specs. Does anyone have an idea why mine does not have the washer and/or what will fix it? Thanks for your help, Tom/Idaho
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|