|
Farmall & IHC Tractors Discussion Board |
Re: Greasable Hubs?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on June 20, 2001 at 04:58:04 from (192.232.119.194):
In Reply to: Greasable Hubs? posted by Brent on June 20, 2001 at 04:12:48:
Brent - I've done that (install zerks in the dust cover) on a couple of implements - it works fine. A couple of tips: 1 - Locate the zerk where it's somewhat protected so it won't get knocked off - i.e. thru the side of the cap. DON'T put it in the center of the cap! 2 - Be careful when adding grease. Filling it too fast or overfilling can blow out the axle seal.
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
