Farmall & IHC Tractors Discussion Board |
Re: Bore increase from 3 to 3 1/8 on B
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on May 23, 2001 at 18:59:39 from (63.25.166.186):
In Reply to: Bore increase from 3 to 3 1/8 on B posted by Dave G on May 23, 2001 at 17:37:51:
head gaskets are the same are you going with flat-top pistons or the hi-dome jobs standard kits can be purchased also where were you going to get the kit prices vary last 3 1/8 with hi-dome pistons and bearings and gaskets was 345 check around for prices can run as high as 120 a hole without bearings get my cranks ground for 62 head will vary as seats guides and so forth new seats guides and ready to run about 125 check around it will pay well ex why does NAPA get 58 for a overhaul gasket set when i can get the same brand for 38
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|