Farmall & IHC Tractors Discussion Board |
Re: 153 ci combine motor in Farmall C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Curt Cooke on May 22, 2001 at 05:43:03 from (12.150.39.226):
In Reply to: 153 ci combine motor in Farmall C posted by Mike S on May 21, 2001 at 21:02:19:
a 153 will fit the C. A 154,(an H motor) will not. The two areas of difficulty are, the crankshaft will have to be removed and bored for a pilot bushing, the power unit crankshafts were not drilled for this. The other challenge is the cooling system, the lower water delivery is different, the upper water exit and waterpump are different and the relative position of the fan in the radiator cowl is different. All of this can be overcome with patience and creativity. Exhaust manifold is also a challenge to make look good. Curt
Follow Ups:
Home
| Forums
Today's Featured Article -
A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|