|
Farmall & IHC Tractors Discussion Board |
about to give up finding problem causing miss
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gene on May 15, 2001 at 13:14:41 from (205.188.195.43):
I have received many suggestions through the discussion board in the past and they have been veery helpful. The tractor, an IH464 gasoline, has been a good tractor except for a problem that I cannoot resolve. I have changed carburetors, coils, condenser, points, plugs, fuel pump, and have found lots of minor problems, but the root problem is still there. The tractor will make what I would call a light popping noise as it occasionally will miss. It will do this at idle most of the time, and when using it in the field under load, it will occur after it warms up. It will purr like a kitten without a miss at all, and when it warms (heats) up, it will start this missing. Sometimes it is a single miss in the middle of running good, other times it may miss a couple of times or more. Could this be vapor lock, or does vapor lock shut it down? There is a gas line that runs next to the block and near the exhaust pipe (within an inch) when it nears the carburetor. I will try to reroute that feed and eliminate that as a possibility. Any suggestions (except just selling it in the Fall/Winter time !). Thanks. I appreciate anyones help or ideas. Gene
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
