Farmall & IHC Tractors Discussion Board |
Re: LOADER HYDRALIC LINES
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Doc on May 08, 2001 at 21:38:58 from (216.177.136.167):
In Reply to: LOADER HYDRALIC LINES posted by Kel Billings on May 08, 2001 at 17:15:27:
Do you have single acting cylinders? If there is a provision for only one hose to each cylinder at one end, these are single acting cylinders and will work fine with existing controls. Route a hose from each cylinder to a hydraulic outlet on each side of the clutch housing. This is what was designed for the tractor. There is power up, weight of loader provides down force. If you have double acting cylinders, 2 ports on each cylinder, you can hook a hose to the end port and put a breather in the middle port. A breather could be gotten at a hydraulic outlet. Godd luck, hope this helped. Doc.
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|