Farmall & IHC Tractors Discussion Board |
Re: Re: Finally...Pictures of my 48 H and Pictures of my home made hitch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Zonie on May 08, 2001 at 20:21:39 from (216.161.156.75):
In Reply to: Re: Finally...Pictures of my 48 H and Pictures of my home made hitch posted by scott on May 08, 2001 at 19:59:41:
Yes I've used it to blade about 1 1/2 acres works great. I just wish it angled. I can tell that I really should have more beefy arms going back to the blade they do flex just a bit. They let the blade chatter on hard ground. I'm still trying to figure out the liftall, some times it lets the blade drop when I think it should hold it up. Anyone know if there is a way to get the lift all hold the blade up at any position other than all the way up? I seem to only be able to get the blade to stay in the all the way up or down positions. Am I asking too much of the old Liftall?
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|