|
Farmall & IHC Tractors Discussion Board |
electrall help!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by brianh on May 07, 2001 at 07:08:40 from (205.188.199.169):
I have an I-H Electrall that someone built up a three-point hitch and a homemade chain-drive reduction gear on to get 3600 RPM out of a 540 RPM PTO. This weekend I was using it and the gearbox went crunch and that was it, now it just grinds and slips. Does anybody out there have the original gearbox that came with the trailer or fast hitch mounted Electrall that they would part with? And as long as I'm dreaming, does anybody also have the correct trailer for it? Or lacking this, does anybody have a PTO type gearbox that would output 3600 RPM out for 540 in, and withstand approx. 25 HP, hopefully cheap? Any help or leads would be appreciated. Thanks in advance, Brian....
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
