Farmall & IHC Tractors Discussion Board |
Re: vaccum lift
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on April 26, 2001 at 06:45:11 from (63.25.166.28):
In Reply to: vaccum lift posted by BOB on April 25, 2001 at 20:10:41:
I USE THE BLUE GASKET MAKER stuff it works great how is your leather and the wall of the cycl I have several of these units they are not vacuum they use the exhaust gas if when you are done with the cycl and it wont hold the load the neoprene washer in the valve assy behind the filter is bad new ones are still avail for 8bucks glad to help these are great units when they are in shape been around them since48 some of the parts are no longer avail and the rest of them are pricey feel free to ask if you have any problems there are a lot of old wives tales about these systems
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|