|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: C front transmission seal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on April 10, 2001 at 19:25:51 from (63.42.174.226):
In Reply to: Re: Re: C front transmission seal posted by haas on April 10, 2001 at 05:24:16:
the term can vary but it is a thin sleeve of a few thousands thick it will go over a bearing journal and bring it back to specks so a seal will be on a surface that is close to speck they work fine you will have to ask your parts counter might be hard to find someone who is familar with the procedure have used them on the input shaft of a HY PUMP ON SC and a crankshaft pulley for a B that is the name used here in IOWA at a local parts store glad to help dont be afraid to ask for more info can ask the counter for some more info to help you
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
