|
Farmall & IHC Tractors Discussion Board |
Re: 1939 M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave T on April 08, 2001 at 08:37:12 from (63.27.107.101):
In Reply to: 1939 M posted by Valerie Wilson on April 08, 2001 at 00:06:12:
There were a few differences. The 39 and early 40 had a smaller Pto shaft, at least the H, A, and B did. Also they used dzus fasteners to fasten the sheet metal. I'm not sure, but I think they, like the H had a recessed transmission cover, where the seat was mounted. This allowed, as far as I could tell, better draining of rain and snow??????? The seat, I think was different too. Somebody else can explain better the magneto than I can. I normally take the tires over to a truck and tractor tire place to drain the calcium chloride, but if it is solidfied, I'm afraid you'll have to have the tire cut off. Do you have a frontend loader? or a friend that has one?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
More Memories of a Field Service Engineer - by Brian Dye. Introduction: The author worked for one of the largest Ford tractor dealerships in England as a trouble-shooter on tractor engines, hydraulics and combine harvesters from 1963 to 1972. In 1972 he became a dealer manager and finally left the dealer net in 1975 to run his own electronic design and manufacturing company. [Editor] We live right in the middle of Norfolk. The dealership that I worked for sold Fordson Tractors from the 1920's and some of t
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|